7.9.5 source distro, AutoOpts not installed

If you will be distributing your project to a system that will build your product but it may not be pre-installed with AutoOpts, you may wish to incorporate the sources for libopts in your project. To do this, I recommend reading the tear-off libopts library ‘README’ that you can find in the ‘pkg/libopts’ directory. You can also examine an example package (blocksort) that incorporates this tear off library in the autogen distribution directory. There is also a web page that describes what you need to do:

http://autogen.sourceforge.net/blocksort.html

Alternatively, you can pull the libopts library sources into a build directory and build it for installation along with your package. This can be done approximately as follows:

tar -xzvf `autoopts-config libsrc`
cd libopts-*
./bootstrap
configure
make
make install

That will install the library, but not the headers or anything else.

This document was generated by Bruce Korb on August 21, 2015 using texi2html 1.82.